WaterPort x SeaSucker Tank Mount
We know a good thing when we see it, and we've seen the WaterPORT 4.0 Gallon Water Tank.
Our WaterPORT x SeaSucker Tank Mount takes all the hassle out of mounting the tank on your vehicle. It attaches with three of our powerful 6" vacuum mounts, letting you put it where it's most needed, most accessible, or even most out of the way. And when you're back to the daily commute, it effortlessly removes to stow away until your next adventure.
Oh, and the WaterPORT 4.0 Gallon Water Tank? It lets you take pressurized water wherever you need it. 3.85 gallons of water available to you wherever you need to clean, rinse, refresh, or just water something down. Add pressure as you fill it with a standard garden hose, or use the optional Pump Cap to pump it up while on the road. You can even connect a bike pump, or air compressor to the included Schraeder valve to add up to 40psi.
Choose between Mount + Tank, or just the Mount.
How strong are the vacuum mounts?
“Strong like bull.” 4.5” vacuum mounts have a rated pull strength of 120lbs, pulling straight out from center. Pull strength on a shear load, i.e. pulling from the side, will be less. 6” vacuum mounts are 210lbs rated. Obviously, putting multiple vacuum mounts on a single product multiplies the maximum holding power.
How long do the vacuum mounts last before they lose power?
There’s no set time limit on our vacuum mounts. It depends in part on the surface you attach to, the condition of the vacuum mount, the load you put on it, and other factors. As for surfaces to attach to, vacuum mounts in general were designed to carry big sheets of glass and other solid surface materials, so smoother, flatter surfaces are ideal. Clean surfaces and clean SeaSuckers go a long way to maximizing the hold time. In any event, if the vacuum mount begins to lose some vacuum, it will warn you so you can get it back to full power before it comes off. The vacuum pump’s plunger will extend from the pump cylinder when it starts to lose power, revealing an orange indicator band. Once you see orange, that’s your cue to repump your SeaSucker. For car racks, the simplest thing to do is to check the rack before you get in your vehicle, and check it each time you stop for gas, food, or the bathroom.
Do I need to clean the surface I’m going to attach my SeaSucker to?
Clean off any surface dirt from the mounting surface before attaching your SeaSucker. While you’re at it, make sure the sealing edge of the vacuum pad is clean too. You don’t have to clean the mounting surface with alcohol wipes, as one overly-enthusiastic customer told us they do, but a quick wipe with a wet paper towel or napkin wouldn’t hurt.
Limited Lifetime Warranty
