Overland Propane Tank Mount
Overland Propane Tank Mount
Overland Propane Tank Mount

Overland Propane Tank Mount

Regular price$ 143.69

/

All-Pro Off-Road's Overland Propane Tank Mount provides a secure mounting system for either a 5-lb. or 10-lb. propane bottle in the bed of your vehicle. Quick-release clamps allow for quick removal of the propane bottle with no need to loosen any strap screws and the included rubber bumpers prevent tank damage that may occur due to rubbing while the tank is installed in the mount. The kit also includes (1) Pack Rack Accessory Mount (P/N 8205-AP-I) for easy mounting to Tacomas or Tundras with the factory accessory bar system installed in the bed.

  • 1/8-inch 5052-H32 aluminum mount
  • Bare aluminum finish
  • Quick-release clamps
  • Supplied with rubber bumpers to securely hold a propane tank
  • TIG-welded
  • Zinc plated hardware
  • Fits 5 lb. 8-inch diameter Manchester, Flame King, and Worthington 1.2 gallon tanks
  • Fits 10 lb. 10-inch diameter Worthington and Trident 2.4 gallon tanks

Note: Not recommended for use with Power Tanks.

 

  

 

 

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

Customer Reviews

Based on 3 reviews
0%
(0)
33%
(1)
67%
(2)
0%
(0)
0%
(0)
G
Geezer Enduro
Nice bracket/mount

Quality seems good, although all the edges were super sharp like cut your hand sharp. I took some sand paper to it and a few minutes later it was much better. Also installation wasn't rocket science but there were no instructions at all. I looked at pictures on their website to figure out what's what. I bought from here since it had the piece that fits into the Tacoma bed tracks. Overall pretty happy.

G
Gavin Gray
Propane mount

Came with absolutely no instructions, not really on Tacoma beast since it’s an an all pro off-road product, even though it isn’t hard to install it still would’ve been nice to have some. I’d almost rather have a strap like system than the tightening system that is on this mount kit, it’s unnecessary and takes forever to tighten when you first get it. Also if you are looking to put this on your bed rack, you may need to go to your local hardware store and get some longer screws to be able to mount it. The screws that come with it are just for the original bed side slits, but if you have a bed rack installed these will most likely be blocked. Besides that the product works and holds the tank well.

J
Josh
Propane tank mount

It's built good. The straps are complicated and a pin to adjust. Their in the scrap bin.


Recently viewed