- Strobe Enabled Switch
- 2 IN 1 Hyper flash LED
- Color: White/ Red
- Clear Smoke lens
- Input Voltage: 12V
- Full Housing Replacement
- Color Temperature: 6500K
- Enhanced Performance LED
- Life Span: Over 50000 Hours
Brake Lighting with Strobe enable switch:
The strobe effect will switch on when the brake is pressed. The light will quickly blink five times, similar to Formula-One race cars. Then the light will illuminate and act as a standard brake light.
Easy Installation, play & plug feature direct-fit replacement to install in just minutes
** Please Note: If your Tacoma has screws on your current 3rd Brake Light, this light will not fit your vehicle
- 2-IN-1 Durable Polycarbonate Stripe/Glossy Lens+ Premium Quality ABS Housing
- Epistar LED Chips: Full Laser high power LED light source provides both a dazzling look and outstanding illumination to the back of your car.
- Sealed with a machine to integrate the lens and housing together tightly and prevent water from getting inside of the lamp.
- High-density EVA on the housing which can prevent water leaking into the car.
- Vetillation film: avoid the moisture issue.
The smoke third light looks great it adds that blackout look.
Removing the factory break light was a pain. But it was worth it because it looks much better and I love it! My only complaint though is the switch did fall off… it was on the setting I wanted before it fell off, so I installed it anyways, but hopefully they make them a bit stronger because if it wasn’t on the setting I wanted, I would’ve had to put my other break light back on without the seal while I waited for a new one to come in, and it rained shorty after… so that wouldn’t have been very good lol