The Rago Fabrication Rock Sliders were engineered from the ground up to provide superior strength and rigidity for the most extreme rock crawling environments. The design is streamlined, low profile, and flows nicely with the factory body lines.
Start with 1.750 DOM tubing as standard on all the rock sliders for extra strength because it's believed seam walled tubing, although sufficient, will not stand up to the extreme off-road environment. The main plate is 3/16 pickled and oiled steel to provide the perfect platform for the fully boxed supports.
These are no ordinary pieces of metal that support the sliders-they are bent at a 45-degree angle on both ends that allows more support for rotational loads and is over 8 inches wide in three different locations. To top it off the U-bent gusset supports every boxed piece for even more rotational strength.
The tubing design is low enough to be used as a step and incorporates a kick out near the rear tire to push the 4Runner past obstacles that may damage the body. It's also designed to be wide enough to protect the body from side damage while on the trails.
The rock sliders are bolt-on using grade 8 bolts on all factory bolt locations. Rago also went the extra mile and designed the sliders to bolt completely through the frame in 4 locations throughout the main plate using 1/2 inch as well as 3/8 inch bolts.
The Details
- 20 Degree angles
- 1 3/4" 120 Wall DOM Steel
- Bolt-On
- Built like a tank
- Billet End Caps
- Raw Steel
Experience the Rago Difference. If you are serious about off-roading, Overlanding, or rock crawling these are the rock sliders for you.